Goldwing RC 9975000025-0, Manual

Page: 23 / 59

All contents copyright 2015, GoldWing RC Version 4.0, June 2015
8. The SU26M has the closed loop pre-installed and crimped at the rudder end. These can be
connected with the M3 bolt and nut. The wire will be left looped inside the fuselage and will need
to be connected to the servo arm.
9. Use your radio system to center the rudder servo and attach either the supplied arm or an
appropriate arm for your servo. Thread one of the ball links about half way onto one of the
threaded couplers. Feed the loose end of one of the cables through a brass tube and then through
the threaded coupler. Holding the rudder centered, adjust the cable length as tight as possible
while checking the ball link position over the servo arm. When satisfied with the position, pinch
the cable around the threaded coupler and then feed the loose end back through the brass tube.
Loop the cable back through the brass tube as before and crimp the brass tube three times just
tight enough not to cut the brass tube but enough to securely hold the wire in place. Cut off the
excess cable with wire cutters. Wick thin CA into the brass tube to help hold the cable secure.
Repeat for the other cable. Hint: Once you have established the position of the threaded coupler
on the cable, you can remove the ball link from the rudder horn to give you more working slack in
the fuselage. Re-install the ball link prior to setting the other cable.