Golden Mask 5+ User Guide
GMD -
www.goldenmaskdetectors.com - Golden Mask Official Distributor
4
Golden Mask 5+ User Guide
GMD -
www.goldenmaskdetectors.com - Golden Mask Official Distributor
5
Main Parts and Assembly
Your Golden Mask 5 comes to you in a box that contain: the detector with telescopic car-
bon shaft and pre-installed 10 x 2500mAh AA NiMh rechargeable batteries (this is subject
to change, while shipping batteries in some destinations is prohibited), a 23 cm (9 inch)
Spider search coil, wireless headphones, smart charger, user guide in English, warranty
card and purchase papers (invoice, payment statement, packing slip - may vary upon pay-
ment method and destination country).
There is nothing special assembling the detector. You have to attach the coil to the lower
stem of the shaft, using the supplied plastic bolt and screw (they are already on their
place), then attach the coil cable to the main unit and you are ready to go.
To extend the telescopic shaft, start from the first section by the side of the coil. Turn the
fixing screw counter-clockwise, pull the search coil gently to the full extent of the carbon
pipe and then fix the section by turning the fixing screw clockwise. Do the same with the
second section. Check if the length is enough, if not, extend the third section to match the
desired length.
WARNING
: The third section can be pulled out completely from the handle part, but we
do not recoomend it, because a plactic shim inside the locking screw could be lost or
damaged. Please, be sure to have a minimum of 15 cm (6 inch) of the third section inside
the fixing screw of the handle section, otherwise the stem will not be stable enough and
could be broken, especially if a large coil is used.
search coil
control box
LCD screen
armrest
headphones
jack
charging
jack
wireless
switch
telescopic
shaft
search coil
attachment
plug
fixing screw
fixing screw
search coil bolt
handle
battery compartment
Operating the Golden Mask 5+
The Golden Mask 5+ is designed to be as simple to operate as possible. The Golden Mask
engineers worked hard to simplify the controls and make your hobby a real pleasure, not a
struggle with endless functions and menus.
The controls of the detector are 9 buttons on the front panel of the control box and a
switch on the back side of the battery box to control the wireless transmitter for the wire-
less headphones.
On the LCD screen are shown all the working parameters of the detector, the TargetID
number and the Spectrum VDI scale, where a graphic of the target signal response is
shown to help identifying the target detected.
On the graphic you can see the LCD screen indicators. Buttons will be explained later.
18 kHz
BITONAL
GB 30
GAIN 1
THRESHOLD 25
P.BOX LOW
+
69
IRON
FOIL NICKEL COPPER SILVER
working
frequency
gain
battery
level
backlight
indicator
target ID
threshold
power box
audio
mode
ground
balance
Iron Audio bar
VDI scale
with type of the
target metal
Spectrum VDI bars
