CAN-bus Cruisecontrol GC90Ci installation manual
10
4
Set-up
4.1
Introduction set-up
These symbols are used for the command module:
i
action
symbol
function
up
SET /ACC
down
RES/DEC
push
ON/OFF
pull
CANCEL
The GC90Ci is supplied make/modelspecific with carefully selected settings. Yet there is
the possibility that the chosen settings are different than the required settings.
In that case it is possible to learn the accelerator pedal and speed signal manually:
refer to § 4.2 The CG90Ci accelerator pedal set-up
refer to § 4.3 The GC90Ci vehicle speed signal set-up
Check during the test drive (§ 4.4) the response time and sensitivity of the cruise control.
Only adjust the response time if the Cruisecontrol engages too slowly or too
aggressively:
refer to § 4.5 Increase response time
refer to § 4.6 Reduce response time
Only adjust the sensitivity if the Cruisecontrol reacts too forcefully or too slowly while
cruising:
refer to § 4.7 Increase sensitivity
refer to § 4.8 Reduce sensitivity