CAN-bus Cruisecontrol GC90Ci installation manual
13
4.4
The CG90Ci vehicle speed signal set-up
This step is only necessary in case the programmed settings of the GC90Ci do not match
the required settings.
Perform the following to learn the GC90Ci to the vehicle speed signal.
Perform step 1-7 within 1 minute!
Step
Action
Confirmation
1
Switch the ignition OFF and ON
2
Start the engine
3
Switch the Cruisecontrol ON
2 low beeps
4
Press and hold the brake pedal during the next 2 steps
5
Operate 4 times
4 beeps
6
Operate twice
2 beeps
7
Release the brake pedal
2 beeps
8
Drive at least 72 km/h (45 mph) and operate once
Cruisecontrol
engages, 1 beep
9
Press the brake pedal once.
2 beeps,
Cruisecontrol
releases
10
Stop in a safe place
11
Press and hold the brake pedal and operate 4 times
1 long beep
12
Release the brake pedal
i
Perform diagnostics if the Cruisecontrol does not engage at step 8. Refer to
chapter 5.0 Diagnostics and trouble shoot
