CAN-bus Cruisecontrol GC90Ci installation manual
5
Always solder the connections and insulate them with vulcanizing tape
Always install the EM in a position where heat, vibration and moisture are
minimized, such as underneath the dashboard
Undo the negative battery terminal before working on the vehicle.
Loss of volatile data is possible (audio, board computer, clock, etc.)
Always use a multimeter when measuring on the vehicle
Cut wires to size, keep them as short as possible
CAN-wires are twisted to assure a reliable operation. Make sure that the
twisting remains the same when the CAN-wires are shortened or extended
As the GC90Ci is supplied model specific, it is not necessary to learn the
accelerator pedal and speed signal. The GC90Ci will operate directly after
installation, unless indicated otherwise when the unit was programmed