CHARGING THE STICK VAC
1.
Ensure that the On/Off switch is in the
“O” position before charging.
2.
Before using the vacuum, charge the unit for 8-10 hours.
3.
Plug the charger jack into the charging base.
4.
Plug the charger directly into a wall outlet, ensuring the charger station is close to
the outlet.
5.
Place the unit onto the charging base. A blue charging light indicates that the
vacuum is properly positioned and that the unit is being charged.
6.
Store the vacuum in the charging base when not in use so that it is always charged
and ready to use.
NOTE:
•
Peak performance may only be realised after the unit has been charged and
discharged two or three times. To maintain peak performance of your vacuum, it is
recommended that the unit be fully discharged then completely recharged at least
once a month. Each recharge will take approximately 12-16
hours’ charging time.
•
The adaptor may become warm during charging
– this is normal.
USING THE STICK VAC
NOTE:
•
The Stick Vac can only be used when the Hand Vac is attached.
•
The Stick Vac and Hand Vac has one power setting only.
1.
Remove the appliance from the charging base.
2.
Slide the
“On/Off” button to the “I” position.
3.
When finished vacuuming, slide the
“On/Off” button to the “O” position.
ASSEMBLY
NOTE:
The dust cup filter must always be used when operating the vacuum.
1.
Before assembling this appliance, ensure that all parts are in the box.
2.
Attach the handle by inserting into the main vacuum unit and ensure a clicking
sound secures the vacuum into place.
3.
Attach the turbo brush head by inserting into the air intake nozzle at the bottom of
the Stick Vac, ensuring that the contact pins are engaged in the connector slots in
the unit. The head is successfully attached when clicked into place.
4.
Attach the Hand Vac unit to the Stick Vac by inserting the Hand Vac air intake
nozzle into the opening located in the main body of the Stick Vac and pushing the
handle gently towards the Stick Vac until it clicks into place.
5.
To open the dust cup compartment, simultaneously press the dust cup release
buttons on the Hand Vac unit and twist to remove. Ensure the dust cup filter is
inside, then re-attach the dust cup container to the Hand Vac unit.
