HEATER CONTROLS
Switch on the Power Button at the rear of the heater to
turn the unit on.
All functions are controlled from the remote control.
For best results, aim the remote directly at the remote
sensor on the front panel of the heater.
The remote has a 3 metre range of operation.
The remote control requires 1 x CR2025 battery
SETTING THE TIME
WEEK
–
press the SET button and MON will show on the
display. Use the
‘
-
’
or
‘+’
buttons to select the day of the
week.
HOUR
–
press the SET button again the unit will switch to
setting the hour. Use the
‘
-
’
or
‘+’
buttons to select the
current hour. (Note it is a 24 hour clock so 2pm is 14:00).
MINUTE
–
press the SET button again the unit will switch to
setting the minutes. Use the
‘
-
’
or
‘+’
buttons to select the
current minutes.
Press the ON/OFF button, the unit will start to blow out air
at room temperature.
Press the MODE button, the heater will operate in Low
Heat Mode.
Press the MODE button again, the heater will operate in
High Heat Mode.
Press the MODE button again, the heater will go back to no
heat and blow room temperature air.
Operating Your Heater
For the Low and High Heat settings the fan remains at the same speed; only the element
changes temperature to create the greater/lesser heat output.
NOTE: To assist in maintaining the internal components, when the unit is turned OFF the
fan will continue to blow room temperature air for a period of 30-60 seconds before
shutting down to standby.
SWING
Press the swing button to allow the outlet louvre to oscillate backwards and forwards to
assist in moving the heated air.
There is a button on the back of the heater below the main power switch. Press this
button to activate
‘Smart Start’,
the heater will turn on in high heat and swing setting.