THERMOSTAT
Selected your desired temperature by pressing either button
“
16
”
to increase temperature up to 32
°
C or
button
“
17
”
to decrease temperature down to 16
°
C.
The selected temperature will be displayed on the control panel. measurement 14 is shown in the display 5.
After a few seconds the display will change back to showing the current room temperature but the set
temperature will be stored and the heater will continue to run until that temperature is reached.
Temperature is measured directly at the appliance using temperature sensor
“
8
”
. It may be some time before
the entire room has also reached this temperature.
TIMER
The appliance has a timer for setting the heating time to between 0.5 and 24 hours. The appliance switches
off automatically once the heating time has expired.
Press timer button
“
18
”
repeatedly until desired running time is shown in display 5.
To switch off the timer, press timer button
“
18
”
repeatedly until running time is no longer displayed.
FROST PROTECTION
To prevent the temperature in a room falling below 0
°
C proceed as follows:
Press the button for selecting heating level
“
21
”
repeatedly until "Frost protection" symbol
“
13
”
appears in
the display.
As soon as the temperature in the immediate vicinity of the appliance drops significantly below 7
°
C, the
heating automatically switches on.
As soon as the temperature rises to above 9
°
C, the heating switches off and the display shows room
temperature again.
To switch off frost protection, press the button for selecting heating level
“
21
”
repeatedly until "Frost
protection" symbol
“
13
”
in the display disappears.
REMOTE CONTROL
All functions that can be operated on the heater can be operated from the remote control.
The remote control takes 2 x AAA batteries. Remove the battery compartment cover and change batteries
observing the correct polarity.
Operating your Appliance
16. Increase temperature
17. Reduce temperature
18. Timer button
20. On/Off button
21. Button for selecting the heat setting
