Goldair GBQ250, Operating Instructions Manual

Page: 19 / 31

Preparation
You will need LPG gas bottle and proper regulators under the gas pressure to operate this gas grill. The
regulators should be comply with EN12864 with current version and national regulation.
Energy saving tips:
a) Reduce the opening time of the lid.
b) Turn the grill off as soon as cooking is completed.
c) Preheat the gas grill for 10 to 15 minutes only. (Except for the first use)
d) Do not preheat longer then recommended.
e) Do not use a higher setting than required.
Connect the hose and regulator to the gas container at the left side of the gas grill. Keeping in mind that
the gas container must be kept away from heat and in a safe position.
The hose dimension is 8mm-10mm diameter.
Installation
After purchasing your gas bottle you will then be ready to set it up with your gas grill.
a)
When changing the gas bottle which shall be carried out away from any source of ignition.
Position the gas bottle can both underneath or at the side of your gas grill, keeping in mind that the bottle
must be kept away from heat and in a safe position.
b) When ready to use your gas grill insert the regulator into the gas bottle valve and tighten firmly.
The Length of hose recommended which shall not exceed 1.5m.
Warning:
Before attempting to light your gas grill you must refer to your lighting instructions and warning
safety points.
Check the hose before each use, searching for cracking, cuts or any abrasions. If the hose is found to be
faulty in any way do not attempt to use your gas grill.
When changing your gas bottle ensures that there are no sources of ignition close by i.e. fires, cigarettes,
naked flames etc. Make sure that the appliance is switched off.
Ensure that the gas hose is not twisted which will affect the gas flow when
using your gas grill. Also the hose must not have undue tension and must not touch any part
of the gas grill which may be hot.