Goldair GBQ250, Operating Instructions Manual

Page: 26 / 31

GAS CYLINDER INFORMATION
• This BBQ is designed to be used with a gas cylinder not exceeding 9KG
• The gas cylinder supply valve must be turned off when the BBQ is not in use.
• Gas cylinders must be stored outdoors, out of reach of children and must not be stored in a
building, garage or any other enclosed area.
• The gas cylinder used must incorporate a safety collar to protect the valve assembly.
• Never store a spare cylinder under the BBQ shelves or inside the trolley housing. Any LPG
cylinder not attached to the BBQ for use should be stored outdoors and well away from the
BBQ.
IMPORTANT:
• When disconnecting and removing the gas cylinder for the purpose of refilling, always
follow these procedures.
• Ensure that all gas control valves on the BBQ and the gas cylinder are turned off before
disconnecting the regulator from the cylinder.
• Do not smoke or use a naked flame near the BBQ or gas cylinder while disconnecting the
gas line between the BBQ and gas cylinder.
• Remove the gas cylinder from the enclosure before disconnecting the regulator from the
BBQ.
• Tighten all connections before placing the gas cylinder back in its enclosure.
• The gas leak testing procedure should be conducted every time the gas cylinder is refilled
and reconnected to the appliance before using the appliance.
REGULATOR CONNECTION
1. Check that all control knobs are in the ‘Off’ position.
2. Make sure the cylinder valve is off.
3. Remove the protective cap from the cylinder, if present.
4. Leak test the connection with a soapy water solution.
(See Gas Leak Testing Procedure)
GAS LEAK TEST PROCEDURE
Never use a naked flame to check for gas leaks. Always use the following procedure to
check for gas leaks.
1. In a small container, mix up a solution of water and detergent/soap. Mix the solution well.
2. Make sure that the gas supply valve on the gas cylinder is turned on.
3. Make sure that the gas control valves on the BBQ are all turned off.
4. Using a brush or spray bottle apply the solution to the gas line and each join in the gas
line.
5. Bubbling of the solution will indicate that there is a leak present.
6. Re-tighten or re-seal any joints that are leaking.
7. If a leak persists then contact Goldair or a Gas Service Agent.