Lighting instructions
Caution
: The lid must be open when lighting the burner!
Do not stand with your face directly over the gas grill when lighting it.
Your gas grill will have following method of ignition:
Pilot Gas Control Ignition:
With all gas controls on the Gas grill in the “OFF” position, turn the gas cylinder valve to the on position at
the regulator. To create a spark you must push the control knob in and hold in this position for 3-5 seconds
to allow gas flow and then turn anticlockwise to ”HIGH”.
You will hear a “snap” from the igniter and you will also see a 3”-5” orange flame coming from the burner
lighting tube at the left side of the burner.
Continue to hold the burner control knob in for two seconds after the “snap”, this will allow gas to flow
completely down the burner tube and insure ignition.
When the burner is alight, adjacent burners will cross light when their controls are turned to “HIGH”
At “High” setting the burner flame should be approximately 12-20mm long with a minimum of orange flame.
Turn the gas control fully anticlockwise for minimum setting.
Should you have any difficulty lighting your gas grill following the above steps, contact your dealer for
advice.
Summary of Contents for GBQ250
