CORNTREAT, PRALINATOR, AND COMBO KANDY KING
MODEL # 2174EL/ER, 2175EL/ER, 2180ER/EL,
2181EL/ER, 2183EL/ER, 2182EL/ER
7
NEW PADDLE & HUB SEAL KIT INSTALLATION
1. Unscrew the wing bolts and remove both mix paddles.
2. Remove the old hub seal assembly.
3. Clean the area around the center hub. Clean up all food and carbon residue.
4. Remove any burrs on the top edge of the center hub. Use a fine grit emery paper to lightly sand the
surface. If the burrs are not removed, damage may occur to the hub assembly during installation.
5. Lightly lubricate the center hub of the kettle with a small amount of vegetable oil to allow for easy
installation of the hub seal assembly.
6. Slide the hub seal assembly down the agitator shaft. Apply pressure to ease the assembly over the
center hub of the kettle until it seats properly. (See diagram below.)
7. After the hub seal assembly has been properly installed, place the new mix paddle on the bottom and
one existing paddle on the top of the agitator shaft.
8. Replace the wing bolts and finger tighten.
Summary of Contents for 2174EL/ER
Page 2: ...SAFETY PRECAUTIONS...
