Goclever CITYB10 SERIES, User Manual

Page: 15 / 39

EN
15
Device Calibration
If the vehicle seems to "pull" to the left or right, it may be necessary to
recalibrate the sensors. This process requires an additional device like spirit
level (preferably two). Many smartphones have free application "spirit level".
Then follow these steps:

Place the board on a flat level surface.

Ensure that the board is off.

Use a level to adjust the level of each wheel. It is important that the two
pulleys are levelled evenly and at the same time.

After confirming that both wheels are properly levelled, press and hold for
about 5 seconds the power button (G) until the blue lights start flashing
and you will hear a beep.

When the LEDs stop blinking calibration is complete.

Turn off the board, turn it back on, and you can use the equipment.
6. Cleaning, storage and transport
Adequate and regular cleaning guarantees safe use and extends the usable
life of the board. All the elements of the board are cleaned using a dry cloth.
Note! Do not use any strong chemicals, caustic, abrasive or disinfecting
chemicals for cleaning, because they may have negative effects on the board
surface.
Note! Do not immerse the board or the battery charger in water or liquids.
Always store the board in a dry, ventilated place, inaccessible to children.
Protect the board against vibrations and shock during transport.
If you are storing your board long-term it is recommended to charge the
battery to about 30% - 50%. Regularly check and recharge the battery if
needed.
7. Explanations