Original Instruction Manual
En
5
10/2016
recommended by the tool manufacturer.
Just because the accessory can be
attached to your power tool, it
does not assure safe operation.
d)
The rated speed of the accessory must be at least equal to the maximum
speed marked on the power tool.
Accessories running faster than their rated
speed can break and fly apart.
e)
The outside diameter and the thickness of your accessory must be within the
capacity rating of your power tool.
Incorrectly sized accessories cannot be
adequately
guarded or controlled.
f)
Threated mounting of accessories must match the grinder spindle thread. For
accessories mounted by flanges, the arbour hole of the accessory must fit
the locating diameter of the flange.
Accessories that do not match the mounting
hardware of the power tool will run out of balance, vibrate excessively and may
cause loss of control.
g)
Do not use a damaged accessory. Before each use inspect the accessory
such as abrasive wheels for chips and cracks, backing pad for cracks, tear or
excess wear for loose or cracked wires. If power tool or accessory is dropped,
inspect for damage or install an undamaged accessory. After inspecting and
installing an accessory, position yourself and bystanders away from the
plane of the rotating accessory and run the power tool at maximum no-load
speed for one minute.
Damaged accessories will normally break apart during this
test time.
h)
Wear personal protective equipment. Depending on application, use face
shield, safety goggles or safety glasses. As appropriate, wear dust mask,
hearing protectors, gloves and workshop apron capable of stopping small
abrasive or workpiece fragments.
The eye protection must be capable of
stopping flying debris
generated by various operations. The dust mask or respirator
must be capable of filtrating particles generated by your operation. Prolonged
exposure to high intensity noise may cause hearing loss.
i)
Keep bystanders a safe distance away from work area. Anyone entering the
work area must wear personal protective equipment.
Fragments of workpiece
or of a broken accessory may fly away and cause injury beyond immediate area of
operation.
j)
Position the cord clear of the spinning accessory.
If you lose control, the cord
may be cut or snagged and your hand or arm may be pulled into the spinning
accessory.
k)
Hold the power tool by insulated gripping surfaces only, when performing an
operation where the cutting accessory may contact hidden wiring or its own
cord.
Cutting accessory contacting a "live" wire may make exposed metal parts of
the power tool "live" and could give the operator an electric shock
.
l)
Never lay the power tool down until the accessory has come to a complete
stop.
The spinning accessory may grab the surface and pull the power tool out of
your control.
m)
Do not run the power tool while carrying it at your side.
Accidental contact with
the spinning accessory could snag your clothing, pulling the accessory into your
body.
n)
Regularly clean the power tool’s air vents.
The motor’s fan will draw the dust
inside the housing and excessive accumulation of powdered metal may cause
electrical hazards.
