go-e Gemini flex, Installation And Operating Manual, Page: 19 / 34

19 19
Starting the charging process
Connect the go-e Charger and the vehicle by
using a type 2 charging cable (or if the car has
a type one socket by using a type 2 to type 1
adapter cable). Make sure that the type 2 plug is
inserted as far as possible into the type 2 socket
of the charger.
The Charger is ready for charging and is waiting
for the car to release it. The LEDs light up yellow
in the number of the preset charging current.
9. Commissioning/charging
Charging
After the car has enabled charging, the LEDs rot-
ate clockwise around the type 2 socket during
the charging process.
The number of „tails“ corresponds to the num-
ber of connected phases or the number of pha-
ses set in the app:
• 1 rotating tail = 1-phase charging (230 V)
• 3 rotating tails = 3-phase charging (400 V)
The speed of rotation and length of the tails in-
dicate the amount of charging current.
You can adjust the charging levels individually in
the go-e Charger app („Current levels“). It does
not matter whether the go-e Charger is connec-
ted single-phase or three-phase.
4.
5.