G
Remove the pump by turning it to the left.
Before doing this release pump rods, turn
them 180° and transmit the srew force via
the back of the zwistlocks on the pump
housing.
G
Filling of the container.
G
Re-insert pump and tighten.
G
Pump up the unit. Observe the safety /
pressure relief valve
(A)
during pumping.
Peak pressure is reached when the safety /
pressure relief valve is triggered. Any ex-
cess pressure will escape through the
safety / pressure relief valve.
G
Press down the lever of the quick-action
valve to spray.
G
Pump up the unit again once the pressure
has dropped to around 1.5 bar so as to
ensure a consistent distribution of the
sprayed liquid.
Emptying and Service
G
Any residual pressure in the tank can be
vented by lifting up the knob on the safety /
pressure relief valve
(A)
. The safety / pres-
sure relief valve can only be actuated with
the device standing upright.
G
Unscrew the pomp carefully, at first only a
few turns by left-hand rotation, so that com-
pressed air being still in the tank can escape.
Only then unscrew the pump completely and
take it out of the tank.
G
Empty and wash out the unit after use.
Note!
Any remaining liquid in the tank
can be emptied out completely through
the filler opening. The type of flushing
liquid to be used and how it is to be dis-
posed of will depend on the details given
by the manufacturer of the liquid to be
sprayed. Also consider whether the tank
is resistant to the flushing liquid.
G
The pump will last much longer if the
pump O-ring
(E)
is lubricated from time to
time with a little resin- and acid-free
grease.
G
Dismantle by pulling the piston rod with the
O-ring
(E)
, and the pump handle
(F)
fully up-
wards, clicking it into the guide stopper
(G)
,
and turning it about 1/8th of a turn anti-
clockwise.
Note!
Above-average use due to manner
of operating (including the tranport to
the place of operation and the storage
when not using the sprayer), influences
of the surroundings (of the place of oper-
ation and the storage place), inadequate
maintenance and care may lead to an
early wear of the sprayer. Therefore, the
16
GB
WARNING!
Contact with cleaning fluids poses a
health risk.
Observe the max. filling amount (see
Technical Data) and the correct dosing given
by the spray producer.
Pull up the safety / pressure relief valve
(A)
by hand and check that it returns to the
starting position.
- Only operate or move device when standing
or hanging upright.
- Inspect all screw joints for tight fitting.
PF50_DE_PL.qxd:PF50.qxd 23.01.2015 19:49 Uhr Seite 16
All manuals and user guides at all-guides.com
