12
Field
Description
Continuous:
After dial-up is successful,
PPPoE connection is always on-line, no matter
whether the data is being transmitted or not.
It is recommended to select it.
Connect on Demand:
After dial-up is
successful, within the preset idle time, no data is
being transmitted, the router automatically
disconnects the PPPoE connection.
In this case, you need to enter the idle time.
Manual:
Select it, you need to dial up and
disconnect the connection mannually.
After setting, click
Next
, the page as shown in the following figure appears.
The following table describes the parameters in this page:
Field
Description
LAN Interface Setup
LAN IP
Enter the IP address of LAN interface. Its valid
value is in the range of 192.168.1.1 to
192.168.255.254. The default IP address is
192.168.1.1
.
LAN Netmask
Enter the subnet mask of LAN interface. Its valid
value is in the range of 255.255.0.0 to
255.255.255.254.
Enable Secondary
IP
Select the checkbox to enable the secondary LAN
IP. The two LAN IP addresses must be in the
different network.
DHCP Server
Enable
DHCP
Server
Select the checkbox to enable DHCP server.
Start IP
Enter the start IP address that the DHCP sever
assigns.
End IP
Enter the end IP address that the DHCP server
assigns.
Max Lease Time
The lease time determines the period that the PCs
retain the assigned IP addresses before the IP
addresses change.
LAN Interface Setup
LAN IP
Enter the IP address of LAN interface. Its valid
value is in the range of 192.168.1.1 to
192.168.255.254. The default IP address is
192.168.1.1
.
LAN Netmask
Enter the subnet mask of LAN interface. Its valid
value is in the range of 255.255.0.0 to
255.255.255.254.
