![background image](http://html.mh-extra.com/html/global/s-8500/s-8500_operating-manual_2232480056.webp)
Global Power Technologies 50
S-8500
Interface
Operation
Specs
SI1 - SCADA Start input
Signal received from the SCADA system
to request a TEG start
5-36 Vin, 1-7mA,
10 seconds minimum
SI2 - SCADA Stop input
Signal received from the SCADA system
to request a TEG stop
5-36 Vin, 1-7mA,
10 seconds minimum
SI3 - SCADA Reset input
Signal received from the SCADA system
to request a reset of the Lockout state
5-36 Vin, 1-7mA,
10 seconds minimum
SI4 - SCADA Auto input
Signal received from the SCADA system
to toggle the Auto Functionality ON or
OFF
5-36 Vin, 1-7mA,
10 seconds minimum
SO1 - SCADA Run output Signal to the SCADA system that the
TEG is running. Blinks during TEG
startup.
Up to 36V,
200mA contact closure
SO2 - SCADA Fuel output Signal to the SCADA system that the fuel
pressure switch is closed, indicating fuel
is available.
Up to 36V,
200mA contact closure
SO3 - SCADA Lockout
output
Signal to the SCADA system that the SI
System failed to start after three spark
attempts.
Up to 36V,
200mA contact closure
SO4 - SCADA Auto output Signal to the SCADA system that the
Auto functionality is ON.
Up to 36V,
200mA contact closure
SO5 - SCADA Local output Signal to the SCADA system that the
TEG is operating in the Local mode.
SCADA start signals are ignored until Lo-
cal mode timeout.
Up to 36V,
200mA contact closure
S1 button - Start
Operator button to manually start the
TEG.
S2 button – Stop
Operator button to manually stop the
TEG.
S3 button – Reset
Operator button to manually reset the
Lockout state.
S4 button – Auto
Operator button to manually switch Auto
functionality ON or OFF.
S5 button – Display
Operator button to turn on the display and
toggle measured values.
S6 button – Adjust
Operator button to toggle through the
adjustable values. Up and Down buttons
can be used to make changes to the
selected value.
S7 button – Up
Operator button for incrementing an ad-
justment.
S8 button – Down
Operator button for decrementing an
adjustment.
Note: All SCADA inputs and outputs accept 16-28 AWG wire.
Table 8 Remote Start Board – Inputs, Outputs, & Switches
Summary of Contents for S-8500
