Global Power Technologies
4
S-8500
2.3 ASSEMBLY
1. Assemble the stand as shown in parts list using the hardware specified on Appendix
F, Figure 20. The mounting brackets must be square before the final tightening of the
fasteners. Squaring of the stand can be accomplished by measuring corner to corner
across the top and adjusting the frame until these measurements match closely.
2. Mount the stand kit on the installation platform using 1/2-13 anchor bolts.
3. Dismantle the crate.
• If using a spreader bar during lifting; use spreader bar and chains or cables connected
to shackles in each of the two lifting lugs, lift the TEG.
• If not using a spreader bar during lifting; remove the exhaust stack and rope gasket
(B2 & B3 in Appendix F, figure 15) to be able to reach the lifting lugs on the TEG.
This is required to prevent damage to the exhaust stack during lifting. Use chains or
cables connected to shackles in each of the two lifting lugs, lift the TEG.
4. Line up the holes on the stand with the holes on
the TEG. Use specified fasteners to assemble the
TEG on the stand (A17 through A19 in Appendix F,
Figure 14).
5. If removed, reinstall the exhaust rope gasket
(B3) inside the groove in the exhaust assembly
(B2). Refit the exhaust assembly (B2 & B3) and
fit the rain-cap (B1 in Appendix F, Figure 14) with
fasteners B10, through B13 in Appendix F, Figure
15.
6. Remove the packaging that supports the resistor
assembly (A3) folded up for transport and loosen
the two hinge fasteners, lift and then rotate down
the resistor assembly so that it is positioned
vertically and retighten the hinge fasteners to lock
the assembly in place. Refer to Appendix C, Figure 10.
7. Apply thread sealant to the fuel line kit as per Figure 1. The fuel line kit includes the
manual shut-off valve and 1/4 NPT nipple (A7 and A8 in Appendix F, Figure 14).
8. Install and tighten the fuel line kit to 1/4 NPT elbow (C14 in Appendix F, Figure 16)
in the fuel system.
DO NOT APPLY SEALANT ON
THE FIRST TWO THREADS
APPLY THREAD SEALANT
OVER THIS AREA
07193 rev1
Figure 1 Applying thread sealant
Summary of Contents for S-8500
