![background image](http://html.mh-extra.com/html/global/gppsts-gray/gppsts-gray_assembly-installation-manual_2232473023.webp)
“
Global Pool Products is committed to engineering and manufacturing world class products in the pool industry
”
Global Pool Products
1330 Pigeon Rd
Bad Axe, MI 48413
Information contained in this document is proprietary and confidential to
P: 989-269-5900 - TF: 866-712-0606
Global Pool Products and not to be reproduced without
Fax: 989-269-5902
written consent from Global Pool Products.
Page | 23
Pool Slide Installation
–
Paver Pool Deck
Tools Required
Chalk Line
Hammer
Hammer Drill
½” Concrete Drill Bit
¾” Socket or Wrench
Hardware
Rip Tide, Tidal Wave, Tsunami
(10)
–
½
” Anchor Studs
(purchased separately) (10)
–
Flat Washers
(10)
–
½’ Hex Nuts
Splash
(8)
–
½” Anchor Studs (purchased separately)
(8)
–
Flat Washers
(8)
–
½’ Hex Nuts
Instructions
1.
Assemble Slide and place it in the desired area while being in compliance with installation location while being
conscious of the safety envelope.
2.
Mark off slide location of where the concrete pad will be poured for the slide with chalk line. All pads are to be
minimum 4” in depth below and below where pavers are to be laid.
a.
Rip Tide
8’ Wide
x 15’ Long
b.
Splash
8’ Wide x 10’ Long
c.
Tidal Wave
8’ Wide x 14’ Long
d.
Tsunami
8’ Wide x 12’ Long
3.
Excavate Pavers if slide is being installed on an existing pool deck.
4.
Once the pad is poured and allowed to cure per the manufacture’s specifications, lay
the pavers.
5.
Place the assembled slide on the pavers over the pad where the slide is centered on the pad.
6.
Use a center punch to mark the slides anchor holes.
7.
Move slide aside and drill holes through pavers and into the concrete pad. You will need to drill
3 ½” into the pad.
Mark off with tape on your drill the thickness of your pavers and an additional 3 ½” so
it does not drill too deep.
8.
Clear holes of any debris that may have fell in with a shop-vac for proper seating of anchor studs.
9.
Insert anchor studs i
nto the holes (recommended length for 1 ½” thick paver is 8 ½” stud)
.
10.
Place your slide over the anchor studs and attach with flat washer and nut (included in hardware kit).
11.
Expand the anchors by tightening the nut.