31
Need help or have any questions? Call us at 1-714-963-0329 or send us an e-mail at [email protected]
❑
Mount the control horn to the aileron, directly behind the
pushrod wire, using two 2mm x 30mm machine screws. Make
sure that the control horn is parallel to the hinge line and that
the clevis attachment holes are over the hinge line.
☞
The centerline of the control horn should be approximately
7-1/4" out from the inside edge of the aileron.
❑
Thread one clevis onto the pushrod wire and snap it into
the
fourth hole
out from the base of the control horn.
❑
Repeat the previous steps to install the second aileron
pushrod assembly on the opposite wing panel.
❑
# 1 Phillips Head Screwdriver
❑
Needle Nose Pliers
❑
Excel Modeling Knife
❑
Electric Drill
YOU'LL NEED THE FOLLOWING PARTS FROM THE KIT:
❑
(1) Nylon Control Horn w/Backplate (small)
❑
(2) 2mm x 20mm Machine Screws
❑
(1) 5-7/8" Threaded Pushrod Wire
SECTION 18: CENTER-FLAP CONTROL SYSTEM INSTALLATION
❑
(1) Nylon Clevis
❑
(1) Nylon 90º Snap Keeper
YOU'LL NEED THE FOLLOWING TOOLS AND SUPPLIES:
❑
5/64" Drill Bit
❑
Ruler
❑
Pencil
❑
Masking Tape
Step 1: Installing the Control horn
❑
Install the control horn on the centerline of the center-
flap, making sure that the base of the control horn is parallel
to the hinge line and that the clevis attachment holes are lined
up over the hinge line.
IMPORTANT
Install the clevis on the
top
of the center-flap
and make sure you are installing the small clevis. If you
install one of the taller clevises, the clevis will hit the wing
mounting block with the wing is installed.
