30
Visit our website at http://www.globalhobby.com or for Customer Service at http://globalservices.globalhobby.com
❑
# 1 Phillips Head Screwdriver
❑
Needle Nose Pliers
❑
Excel Modeling Knife
❑
Electric Drill
YOU'LL NEED THE FOLLOWING PARTS FROM THE KIT:
❑
(2) 3-1/8" Threaded Wires w/90º Bend
❑
(2) Nylon Control Horns w/Backplates
❑
(4) 2mm x 30mm Machine Screws
SECTION 17: AILERON CONTROL SYSTEM INSTALLATION
❑
(2) Nylon Clevises
❑
(2) Nylon 90º Snap Keepers
YOU'LL NEED THE FOLLOWING TOOLS AND SUPPLIES:
❑
5/64" Drill Bit
❑
Ruler
❑
Pencil
❑
Masking Tape
Step 1: Installing the Aileron Pushrod Wires
❑
Using a modeling knife, cut away all but one arm from a large "4-point" servo horn.
❑
Enlarge the
fourth hole
out from the center of the servo arm using a 5/64" diameter drill bit.
❑
Install the 90º bend in one 3-1/8" long pushrod wire into
the hole that you just enlarged, using the snap keeper
provided. When installing the snap keeper, make sure it
"snaps" firmly into place over the pushrod wire.
☞
The pushrod wire should be on top of the servo arm.
❑
Install the servo arm assembly making sure that the
servo arm is centered and points toward the wing tip.
❑
Install and tighten the servo arm retaining screw.
❑
Use a couple of pieces of masking tape to hold the aileron centered.
Step 2: Installing the Control Horn & Clevis
❑
Connect your radio system and plug the aileron servo lead into its proper slot in the receiver. Double-check that the
aileron trim lever on your transmitter is centered.
