Glion 510 B1, User Manual

Page: 35 / 41

211026v1
PRE-RIDE SAFETY CHECKLIST
Notice: Before every ride, and after every 25-45 miles (40-72 km), we advise following the pre-ride
safety checklist.
Safety Check
Basic Steps
1. Brakes Ensure front and rear brakes work properly.
Check brake pads for wear and ensure they are not overworn.
Ensure brake pads are correctly positioned in relation to the rims.
Ensure brake cables are lubricated, correctly adjusted, and display no obvious
wear. Ensure brake levers are lubricated and tightly secured to the handlebar.
Test that the brake levers are firm and that the brake, motor cut off functions, and the brake light
are functioning properly.
2. Wheels and Tires Ensure tires are inflated within the recommended limits posted on the tire sidewalls and hold air.
Ensure tires have good tread, have no bulges or excessive wear, and are free from any other
damage. Ensure rims run true and have no obvious wobbles, dents, or kinks.
Ensure all wheel spokes are tight and not broken.
Check axle nuts and front wheel quick release to ensure they are tight. Ensure the locking lever
on the quick release skewer is correctly tensioned, fully closed, and secured.
3. Steering
Ensure the handlebar and stem are correctly adjusted, tightened, and allow proper steering.
Perform a handlebar twist test (see assembly step 4) to ensure the stem riser clamp bolt
security. Ensure the handlebar is set correctly in relation to the fork and the direction of travel.
4. Chain Ensure the chain is clean, oiled, and runs smoothly.
Extra care is required in wet, salty/otherwise corrosive, or dusty conditions.
5. Bearings Ensure all bearings are lubricated, run freely, and display no excess movement, grinding, or rattling.
Check headset, wheel bearings, pedal bearings, and bottom bracket bearings.
6. Cranks and Pedals Ensure pedals are securely tightened to the cranks.
Ensure the cranks are securely tightened and are not bent.
7. Derailleur and
Mechanical Cables
Check that the Derailleur is adjusted and functioning properly.
Ensure shifter and brake levers are attached to the handlebar securely.
Ensure all shifter and brake cables are properly lubricated.
8. Frame, Fork, and
Seat
Check that the frame and fork are not bent or broken.
If either frame or fork are bent or broken, they should be replaced.
Check that the seat is adjusted properly, and seat post quick release lever is securely tightened.
9. Motor Drive
Assembly and
Throttle
Ensure hub motor is spinning smoothly and motor bearings are in good working order. Ensure all
power cables running to hub motor are secured and undamaged.
Make sure the hub motor axle bolts are secured and all torque arm and torque washers are in place.
10. Battery Ensure battery is charged before use. Ensure there is no damage to battery.
Lock battery to frame and ensure that it is secured.
Charge and store bike and battery in a dry location, between 50 °F
– 77 °F (10 °C – 25 °C).
Let bike dry completely before using again if it gets wet.
11. Electrical Cables
Look over connectors to make sure they are fully seated and free from debris or moisture. Check
cables and cable housing for obvious signs of damage.
Ensure headlight, taillight, and brake light are functioning, adjusted properly, and unobstructed.