Glion 510 B1, User Manual

Page: 5 / 41

211026v1
When operating the bike at a higher power assist level, the hub motor should provide a smooth, gradual
acceleration of the motor's power. Should the power assist or motor levels function abnormally,
intermittently, or not work at all, please stop using your E-bike immediately and contact our support
team for assistance.
BRAKES
Ensure that brakes function normally and all components of the braking system are properly secured
without any damage. When you fully squeeze the brake levers, ensure that neither the front nor the
rear brake lever touches the handlebars and that the wheels are locked. Add tension to the brake cables
or take your bike to a certified bike mechanic to have the brakes repaired when you face any problems.
WARNING : Do not touch the brake rotor . Touching the brake rotor, which has sharp edges and
can get very hot while you're riding, can cause serious injury, slicing damage, or burns. The
brake rotor heats up from normal friction when the brake pads press against the brake rotor to slow or
stop the bike. Touching the brake rotor with bare skin can also transfer natural oils to the rotor, which
can decrease braking performance. Do not touch the brake rotor, especially when it's in motion or after
you've been riding your bike. Touch the brake rotor only for necessary maintenance when it is cool, not
moving, and while you are wearing gloves or using other appropriate protective equipment.
RIMS AND TIRES
Your tire rims should always spin straight and must be repaired or replaced if they wobble from side to
side or up and down when spinning. If your rims become untrue or spokes loosened, which could
happen due to shipping or after use, we recommend having a certified bike mechanic tune the rims of
your E-bike. Do not attempt to tune rims or tighten spokes unless you have adequate knowledge, tools,
and experience. Inspect the tires for any physical damage and they are filled to the proper air pressure
as indicated on the tire sidewall. Do not ride the bicycle with a tire that is physically damaged or is low
or flat. Tires without the correct amount of air pressure could reduce performance, cause tires to wear
faster, and make riding your bike dangerous. See the Tire Inflation and Replacement section of this
manual for more information.
QUICK RELEASE LEVERS
Quick release levers are for securing the seat post and handlebar height adjustment. They allow the user
to adjust the seat post and handlebar height without tools. Since quick release levers could be loosened
during transportation, or accidentally between or during rides, it is important that you regularly check to
ensure these quick releases are properly tightened.
WARNING: Failure to properly tighten, fully close, and secure the quick release clamps on your
E-bike before riding could lead to loss of control causing serious injury or death.
HANDLEBAR, GRIPS, AND SEAT ADJUSTMENTS
Make sure that the handlebar and the handlebar stem are properly aligned, fitted to the user, and
tightened to their corresponding, recommended torque values. Handlebar grips should not move easily
at the ends of the handlebar. Loose, worn, or damaged handlebar grips should be replaced before
riding. The handlebar, seat and seat post should be properly aligned, fitted to the user, and the seat
post and handlebar quick releases should be properly tightened, fully closed, and secured before riding.