Glentek SMB9675-1A-1, Installation & Operation Manual

Page: 16 / 36

Fadal is a trademark of Fadal Machining Centers, we have no affiliation with Fadal or Mag IAS
Once the program is loaded jog the z axis down so the screw can be indicated.
Type “SETZ” and press ENTER. Start the test program and observe
the program is running correctly. Depress the SINGLE STEP key. Be sure the test
screw returns to its original position.
Set the indicator as shown below, the tip must be touching the lower thread
halfway into the thread, the second thread from the bottom.
Run the test and observe the indicator. The reading should not deviate from zero
More than .002” on either side of zero.
If necessary consult the FADAL maintenance manual for your machine.
TEST SCREW TEST SCREW W/ TOOL HOLDER
TEST SCREW IN SETUP WITH DIAL INDICATOR
14