Glentek SMB9675-1A-1-7700, Installation & Operation Manual

Page: 6 / 33

Chapter One www.glentek.com
6 MANUAL # 9675-1035-000-A
1.3 Mode of Operation
Changing the Mode of Operation dial (SW1) (see pg. 26) will modify the configuration of the spindle
drive. Aligning the dial to any of the positions listed below will alter the drive to those settings. If none
of the settings below match your preference please contact one of Glentek’s sales engineers for
assistance. The drive is shipped with the dial at position 0 (zero)
Mode of Operation Position Settings
Position Power (HP) RPM Sensor/VFD Part Number Model Number
0 15 10K Sensor 7700 SMB9675-1A-1-7700
1 15 7.5K Sensor 7701 SMB9675-1A-1-7701
2 15 10K VFD 7702 SMB9675-1A-1-7702
3 10 10K Sensor 7703 SMB9675-1A-1-7703
4 10 7.5K Sensor 7704 SMB9675-1A-1-7704
5 10 10K VFD 7705 SMB9675-1A-1-7705
6 20 10K Sensor 7707 SMB9675-1A-1-7707
7 20 7.5K Sensor 7708 SMB9675-1A-1-7708
8 20 10K VFD 7709 SMB9675-1A-1-7709
9 5 10K Sensor 7710 SMB9675-1A-1-7710
A 5 7.5K Sensor 7711 SMB9675-1A-1-7711
B 5 10K VFD 7712 SMB9675-1A-1-7712
C - - - - -
D - - - - -
E - - - - -
F - - - - -
Note : Positions C, D, E, and F are reserved for future configurations.
Note: Align the dial to the desired configuration before installation or disable the drive with an M5
(spindle stop) command BEFORE rotating the dial. The four place seven-segment displays will
display the operation mode selected (i.e. 7700, 7701, etc.) for seven seconds, then reverts to
displaying motor rpm. Enable the drive to run in the new mode.