Glenayre Document Number: 9110.01002
GL-T8541 PA
09/10/99
SPECIFICATIONS
t8541
p2.
fdk
Copyright © 1997 Glenayre
Page: 2-1
2
SPECIFICATIONS
2.1 General
Table 2-1, PA Specifications, lists the specifications of the PA. Unless noted, all equipment
tests were performed per the ANSI/EIA-603/1992 standard, “Land Mobile FM or PM
Communications Equipment Measurement and Performance Standards,” approved Octo-
ber 27, 1992, and dated February 1993.
Also refer to the specifications within the transmitter system manual and the exciter man-
ual. Specifications listed here are limited to the characteristics of the power amplifier, not
the transmitter system.
2.2 GL-T8541 PA Specifications
Refer to Table 2-1, PA Specifications, for power amplifier specifications.
Note: the specifications are subject to change without notice.
Table 2-1 PA Specifications
Characteristic (unit of
measurement)
Condition
Specification
Height
Fits inside transmitter
chassis
5.25 in (13.3 cm) : 2 rack units
Width
19 in (48.3 cm)
Depth
13 in (33 cm)
Weight
Without exciter
27 lb
RF input power
Nominal, supplied by
exciter within tx chassis
250 mW (25 +/-2 dBm)
RF output power range
100-250 W
Duty cycle
At full power
100% Continuous
RF bandwidth
Band determined by
sales order
395 to 420 MHz
420 to 445 MHz
445 to 470 MHz
470 to 495 MHz
495 to 512 MHz
RF output impedance
Nonreactive
50 ohms
RF output connector
At rear of PA shelf
Type N (female)
Maximum VSWR
1.5:1
Spurious output
-90 dBc (or -36dBm if less)