gledhill SysteMate 125, Installation And Servicing Instructions

Page: 6 / 44

Supplied By www.heating spares.co Tel. 0161 620 6677
Page 6 Page 7
SY
STEMA
TE
2000
�
�
�
�
�
�
��
��
�
�
�
��
1.2 TECHNICAL DATA
Standard Equipment
The standard configuration of the SysteMate
2000 is shown opposite. The Appliance Control
Board (A.C.B.), mounted inside the appliance,
controls the operation of the complete system.
The A.C.B. is pre-wired to a terminal strip
where all electrical connections terminate. It
is supplied with the following factory fitted
equipment:-
1. Space heating pump
2. Domestic hot water primary
(plate heat exchanger) pump
3. Boiler pump
4. Hard water appliance control board (A.C.B.)
5. Electro-mechanical clock to control the
space heating (in conjunction with room
thermostat - if fitted)
6. Expansion vessel for the primary/heating
system (supplied separately)
7. Plate heat exchanger
8. DHW temperature sensor
9. PHE return sensor
10. Store temperature sensor
11. Y type strainer/flow regulator
12. A feed and expansion cistern for filling
the primary thermal store (complete with
cold feed/open vent pipework assembly)
is supplied separately.
Optional Extra Equipment
* A soft water model is available for areas
where the hardness level is below 200
p.p.m. (mg/ltr)
* Flexible connection kit for use in
connection with suitable push fit
connectors for quick connection to first
fix pipe installation.
* ‘Switch’ emergency electrical back-up
for hot water and/or heating in the event
of a boiler fault.
* A seven day digital clock/programmer
to control the space heating (in
conjunction with a room thermostat if
fitted).
* A kit to site the clock/programmer
remotely.
* A no clock option - because of the
design of the appliance it should not be
necessary to fit anything other than a
single channel clock to control the
heating system.
* 15mm 3 bar pressure relief (safety) valve
for fitting near the boiler (see boiler
manufacturers recommendations.
* Pressure gauge and filling loop for fitting
near the boiler.
* Hot and cold water manifolds for use
with plastic pipework.
* Ballvalve/overflow connector for F & E
cistern.
1.0 DESIGN
Appliance Control Board
A.C.B.
Electro-mechanical clock
programmer
Digital clock programmer
Switch