gledhill SysteMate 125, Installation And Servicing Instructions

Page: 26 / 44

Supplied By www.heating spares.co Tel. 0161 620 6677
Page 26 Page 27
SY
STEMA
TE
2000
2.3 COMMISSIONING
Fully flush and, when necessary, chlorinate
the hot and cold water system in accordance
with the recommendations in the Model Water
Byelaws and BS 6700.
Commissioning the SysteMate Control
System
The SysteMate control system will automatically
commission itself to match the actual
performance of the installed boiler but the
thermostat on the boiler should be left at
maximum initially.
The control system/A.C.B has been initialised at
the factory and will operate automatically.
However, the operation of the control system
should be checked as follows on the A.C.B
(shown opposite).
1. Set the boiler thermostat to MAXIMUM
2. Switch off heating on the clock/
programmer and room thermostat
3. Check the jumper settings are correct.
These must all be in the correct positions
for the appliance to work correctly - see
opposite for options.
4. Switch on the mains supply.
The A.C.B. will automatically commission
itself to suit the sytem/boiler and the
dot after the ON the LED display will
flash:
2.0 INSTALLATION
Once the system is finally filled turn down
the servicing valve for the ballvalve in
the F & E cistern to the point where the
warning/overflow will cope with the discharge
arising from a ballvalve failure.
If an overflow is not provided ensure the
temporary connection to the ballvalve is
isolated and removed from its connection
to the cold water supply.
Cleansing Hot/Cold Water System Treatment
e.g.
�
�
�
�
��������� ������� ����� �������
� � ��� ���� �� ���� ���������
� � ������� ���� ��
� � ������ ���� ��
� � ������ ��
�����
�����
����
������
��������
���
���
�
��� �������
��� � � ��
��� � � ��
��� � � ��