Page 22
The Registered Installer is responsible for the safe installation and operation of the
system. The installer must also make his customer aware that periodic maintenance
of the equipment is essential for safety.
Maintenance periods will vary for many reasons. Gledhill Building Products Ltd
recommend a maximum of 12 months to coincide with boiler maintenance.
Experience of local water conditions may indicate that more frequent maintenance is
desirable, eg, when water is particularly hard, scale-forming or where the water supply
contains a high proportion of solids, eg, sand. Maintenance must include the following:
1. Check and clean filter
2. Manually check the operation of the temperature relief valve.
3. Manually check the operation of the expansion relief valve.
4. Check discharge pipes from temperature and expansion relief valves are free from
obstruction and blockage and are not passing any water.
5. Check the condition and if necessary descale the heat exchangers in hard water
areas.
6. Check that water pressure downstream of pressure reducing valve is within the
manufacturers limits.
7. Check operation of motorised valve.
8.
Check and advise the householder not to place any clothing or other combustible
materials against or on top of this appliance.
9. On completion of the work, fill in the Benchmark Service Record towards the back
of this manual.
After servicing, complete the relevant Service Interval Record section of the Benchmark
Checklist located on the inside back pages of this document.
IMPORTANT NOTE
When draining down the appliance for any reason, the instructions
provided in the Commissioning Section (Page 20) MUST be followed to
prevent potential damage to the cylinder.
SERVICING AND MAINTENANCE
SERVICING AND MAINTENANCE
Summary of Contents for PLATINUM D120
Page 45: ...Page 45 NOTES ...
Page 46: ...Page 46 NOTES ...
