Glastender, Inc. 5400 North Michigan Road Saginaw, MI. 48604-9780
800.748.0423 989.752.4275 Fax: 989.752.4444 www.glastender.com
BIK-Y
Beer Panel Installation Instructions
F-750-362 Rev. A
These instructions assume that the primary regulator and CO2 line to the walk-in cooler are already installed.
1. Position the regulator panels according to factory instructions.
2. Connect CO2 source line to one end of regulator bank (A). If there is more than one panel, continue the line
to the next panel until all panels are connected
3. Approximately 9 feet of clear vinyl beer line (B) is provided for the keg jumper line from each keg to its Y
angle bracket (C). Trim clear line to size and attach one end to bottom of Y angle bracket and the other end to
the keg tap.
4. Approximately 9 feet of red air line (D) is provided for the jumper line from each keg to its regulator (E). Trim
red air line to size and attach one end to the regulator and the other end to the keg tap.
5. Attach the polyline (F) provided in the beer line set (conduit) to the two top output ports of each Y angle
bracket (C).
6. The keg regulators (E) provide individual pressure to each keg. Upon start up, the ideal gauge pressure will de-
pend on the type of gas involved as well as the length of the line runs. Since each keg is being split to dispense
out of two different faucets, the line runs between those two faucets must be balanced. The goal is to achieve
a flow rate of 2 ounces per second. If you do not have an even flow rate out of each of the two faucets and are
not certain of how to balance the system, consult the factory.
A
F
E
B
C
D
04-06-06
