Glastender, Inc. 5400 North Michigan Road Saginaw, MI. 48604-9780
800.748.0423 989.752.4275 Fax: 989.752.4444 www.glastender.com
BIK
Beer Panel Installation Instructions
F-750-360 Rev. A
These instructions assume that the primary regulator and CO2 line to the walk-in cooler are already installed.
1. Position the regulator panels according to factory instructions.
2. Connect CO2 source line to one end of regulator bank (A). If there is more than one panel, continue the line
to the next panel until all panels are connected.
3. Approximately 9 feet of clear vinyl beer line (B) is provided for the keg jumper line from each keg to its angle
bracket (C). Trim clear line to size and attach one end to bottom of angle bracket and the other end to the keg
tap.
4. Approximately 9 feet of red air line (D) is provided for the jumper line from each keg to its regulator (E). Trim
red air line to size and attach one end to the regulator and the other end to the keg tap.
5. Attach the polyline (F) provided in the beer line set (conduit) to the top of each angle bracket (C).
6. The keg regulators (E) provide individual pressure to each keg. Upon start up, the ideal gauge pressure will
depend on the type of gas involved as well as the length of the line runs. The goal is to achieve a flow rate of
2 ounces per second.
A
F
E
B
C
D
04-06-06
