Glas-Col Temp-O-Control TOT-1200, Operating Instructions Manual

Page: 6 / 15

6
OPERATION
The operational descriptions have been illustrated with displays from the
controller. The nature of a seven-segment display makes it difficult to create and convey
messages. At the end of this manual are all of the menu items available in this controller.
INITIAL POWER UP
When the power is first turned ON, all of the characters will appear on the Display. This
is the normal segment test mode.
In approximately 5 seconds the process temperature (PT), as read by the thermocouple,
will appear on the display in red and the set point temperature will appear on the right
side of the display in green.
Congratulations you are now ready to start controlling your process.
SETTING THE SET POINT
Coming from the factory, the Set Point is set a 50.0

C. To adjust the Set Point
temperature, use the UP and DOWN arrow. The SET POINT will be displayed in green
on the right side of the display.
Note
The Set Point changes slow at first then picks up speed after 3 seconds.
So if you’re only changing a few degrees, change the Set Point by just pushing
the appropriate arrow key.