Glas-Col Temp-O-Control TOT-1200, Operating Instructions Manual

Page: 4 / 15

4
REAR PANEL CONROLS AND CONNECTIONS
1) Lab Rod Clamp - Can be used to mount the Temp-O-Control
on an equipment frame. This will allow the
user more bench space. The clamp will
mount to any ½ inch diameter rod.
2) Alarm - This is a Sonalert device. This alarm is
turned ON and OFF by the Front Panel
switch. Only on TOT-1200A models.
3) Fuse - Protects against circuit overload. (See
specifications for fuse and load
specifications.)
4) Power Receptacle - Accepts a removable type line-cord with a
three prong grounded plug, for use in
standard 120 Volt, 15 amp wall receptacles.
CONTROLLER MODULE DESCRIPTION
The illustration above is of the front panel controller module on the Model TOT-
1200 Temperature Controller. The table that follows is an explanation of the
display, indicators and switches.
1. Display -
Display the Process Temperature (PT), the Set Point Variable
(SP), Programming variables, codes and Error messages.
2. Main Setpoint -
This indicator will illuminate when power is applied to the
output receptacle. This is controlled by the Set Point Variable
One (SP1).
Caution!
Use only the specified replacement line cords. (See specifications for the line cord
ratings.)