30
GB/AU
CABIN MODE (CA)
Important to know!
In cabin mode any temperature you select will be automatically saved.
The reason: Should someone leave the cabin having selected a low, frost-safe temperature without any further action, this setting will be saved and
will continue after a power cut, whatever its length. This will ensure that unattended periods will always have a low temperature setting, and energy
consumption will stay at a minimum. After a long power cut the thermostat will start up with the lower temperature setting, whether it is the comfort
or the cutback value.
Startup and Reset
- must be carried out after a long power cut or at first time use.
A Startup/Reset procedure has to be performed to initiate the correct mode and function of the thermostat.
IMPORTANT: there are two different startup sequences
1) If °C-17-rE is flashing in the display: go to procedure A.
2) If HO is flashing in the display: go to procedure B.
The procedure must be completed in one continuous sequence to be valid. Should the procedure be performed incorrectly or fail, switch off the heater
and start a new reset procedure.
Startup procedure A – if the thermostat has been connected and
switched on beforehand:
On switching heater on, the
sequence °C – 17 – rE - will flash
in the display.
This means that the thermostat has
been disconnected for a long period
and needs to be restarted.
To set the thermostat back to the fac-
tory default, switch off the heater using
the main power switch.
Press and hold in and at the same
time switch on using the main power
switch.
Continue to press until rE flashes in
the display, then release .
You can choose between the modes HO
(Home), OF (Office) and CA (Cabin) by
pressing the or key.
Confirm your choice by holding in the
key for more than 5 seconds.
22 (°C) will flash. Select your preferred
comfort temperature.
Confirm by holding in the key for
more than 5 seconds.
If you do nothing, 22 (°C) will be
stored automatically after 7 seconds.
Startup procedure B – if the thermostat has never been switched on
since leaving the factory:
When the heater is switched on, HO
(Home mode) will flash in the display.
You can select between modes HO, OF
(Office) and CA (Cabin) by pressing the
or key.
Confirm your choice by pressing in
key for more than 5 seconds.
22 (°C) will flash. Select your preferred
comfort temperature.
Confirm by pressing in the key more
than 5 seconds.
If you do nothing, 22 (°C) will be
stored automatically after 7 seconds.
Starting the temperature cutback function
Press for 5 seconds. d (days) will
flash 3 times. 01 (days) will flash
continuously.
Select the number of days you want
the period to last by pressing the or
key. (The number can be from 01
to 40 days)
Confirm by pressing .
10 (ºC) will flash.
Select the frost-safe temperature with
the or key.
Confirm by pressing .
The frost-safe temperature will be
displayed and LEDs 7 and 5 will flash
slowly.
After a few seconds HO will flash in
the display.
