32
ENGLISH
4 INSTALLATION
4.1 Appearance
Figure 2. Appearance
Alternating current indicator lint: the light is green when powered on.
Probe jack: it is used to connect Oximeter probe to measure the oxygen saturation, pulse rate and PI.
Alarm lamp: When data’s going beyond the limits, low-voltage, finger out, sensor off or sensor fault, the
alarm light will be on.
Display area: display measure information.
Button Area:
1. Mode switch button: click it to switch mode (Measure interface 1 / Measure interface 2)
2. Alarm pause/confirm button: when alarm happens, short press it to make alarm sound pause. The
pause time could be set by menu. Long press it to confirm the alarm, and there will be no alarm this
time.
3. Return button: return to the previous menu.
4. Up button/down button/left button/right button: change the choice bar position left/ right button: set
part function.
5. Menu button: in waveform measure interface, press the button to enter the menu setting; in menu
interface, press the button to enter the corresponding submenu.
6. Power button: in power-off state, long press the button to turn on the device; in power-on state, long
press the button to turn off the device.
USB port: It is used to connect computer to transmit data by data line.
Power supply jack: power supply line interface.
Note: During data transmitting, please do not use this device.
