Operative Manual
MO082-IT
22/04/13
Rev.0
Pag. 6 di 12
2.
Product Installation
Before installing the Product, make sure that all the packages are present and in good condition, without any
transport-related damage, and that the contents correspond to what is specified above.
Claims will be considered only if the seller or the forwarder are informed immediately. Each claim must be
in writing. Goods are always carried at the buyer’s risk.
Keep the original package in case the lamp must be sent back.
2.1 Installation mobile version
1.
Insert the lamp into the upper hole of the pipe.
2.
Screw down the knob, taking care of the thread
3.
Connect the power cable plug to the network line (please check that the network line is
equipped with the ground cable).
2.2 Installation wall version (S/12 MED fixing)
1.
Fix the clamp S/12 MED on the wall using 3 expansion screws.
2.
Insert the lamp into the upper hole of the wall clamp S/12MED.
3.
Follow points 2 and 3 of paragraph
2.1
.
2.3 Installation wall version (rail bar fixing)
1.
Fix the rail bar supports using 2 expansion screws.
2.
Put the clamp on the bar and tighten the handle.
3.
Insert the lamp into the upper hole of the rail clamp
4.
Follow points 2 and 3 of paragraph
2.1
.
2.4 Installation table version (S11 fixing)
1.
Fix the clamp S/11 to the table tighten the screwed pivot.
2.
Insert the lamp into the upper hole of the table clamp
3.
Screw, using a screwdriver, the screw on the back of the clamp,
4.
Follow point 3 of paragraph
2.1
.
2.5
First starting
At this point is possible to power the Product to check its correct functioning.
Follow the steps below:
1-
Press the green switch of the base;
2.6
Installation verification and Product testing operations before use
The following prescriptions are to be considered compulsory during verification of the installation, since they prove
the correct execution of all the points set out. For such reason it is necessary to tick each point when it is treated.
1.
Check the suitability of the wall to the installation of the Product.
2.
Check the right installation of the pivot into the clamp/stem
3.
Make sure the movement mechanism works perfectly. Check the mechanical operation of the Product
by directing and rotating
4.
After turning on the Product, it must emit light from the reflector
Seal and signature of the installer:
