Gilras GRU-5000 A, Operation Manual

Page: 58 / 68

Annex B Prompt Message
- 49 -
Annex B Prompt Message
1.
System start-up prompt:
Switch on the system, it will read parameter and self-check,
displaying "THE SYSTEM IS CHECKING …PLEASE WAIT…". After checking, it will enter the
normal interface.
2.
Probe checking prompt:
If probe is not connected, the system will prompt automatically
when scanning. The dialogue box will display "PLEASE CHECK THE PROBE!" reminding you
to check the probe connection.
3.
Nothing Selected prompt:
If the operation is wrong and unable to select the correct item, the
dialogue box will prompt "PLEASE SELECT AN ITEM!" or "NO DATA!", indicating that no
correct item is selected.
4.
Confirming prompt for deleting or saving:
When deleting some item or saving the result of
a patient's case, the dialogue box will pop up. "ARE YOU SURE TO SAVE?" prompts to
confirm saving or not. "ARE YOU SURE TO DELETE?” prompts to confirm deletion or not.
"ARE YOU SURE TO CLEAR ALL THE DATA PERMANENTLY?" prompts the cleared data
are not recoverable and whether to continue the clearance. "ARE YOU SURE TO DELETE
THE ITEM PERMANENTLY?" prompts the deleted data are not recoverable and whether to
continue the deletion.
5.
Whistle prompt:
a) Three short beeps of buzzer "beep - beep - beep" prompt measurement failed.
For A Biometer, please check if measurement is performed for eight groups of data.
b) A long beep of buzzer "beep-" prompts measurement completed.
Under automatic measuring status for A Biometer, it prompts the measurement for eight
groups of data have been completed.
c) A short beep of buzzer "beep" prompts single measurement completed.
Under automatic measuring status for A Biometer, there will be a short beep each time when
proper data have been acquired, then the data will display in the corresponding group of
cursor.