Gill Instruments Ltd
_____________________________________________________________________________________________________________
________________________________________________________________________________________________
WindObserver II (WindObserver FC)
Page 23
Issue 2
Doc. No. 1390-PS-0011
June 2007
8.6. Unit
Identifier
N X
Changes the Unit Identifier to ‘X’.
‘X’ can be any letter from B to Z.
Note that the default Unit Identifier A should not be used when networking units.
8.7. Units
Units
metres/sec
(m/s)
knots
(knots)
miles / hour
(MPH)
kilometre/hour
(kph)
feet / minute
(fpm)
Configuration
code
U1
U2
U3
U4
U5
8.8. Output
rate
Outputs per second
1
2 4
Configuration code
P1
P3
P2
8.9. Averaging
Setting
Configuration code
Averaging (Default)
G0000
Enter the required averaging period in seconds as a four-figure number between 0000 and
3600.
8.10. Heating
Heating is autonomous and requires no set-up once activated.
Setting
Configuration code
Disabled
H1
Activated
H2
Each transducer is heated independently and will be active when ambient temperature
drops below approxi15ºC each transducer will de-activate when +25ºC threshold
is reached.
8.11. NMEA
Setting
Configuration code
NMEA string “IIMWV”
K1
NMEA string “WIMWV”
K2
8.12. Vertical Output Padding
Setting
Configuration code
Disable vertical output padding
V1
Enable vertical output padding
V2