Gill Instruments Ltd
_____________________________________________________________________________________________________________
________________________________________________________________________________________________
WindObserver 65
Page 25
Issue 4
Doc. No. 1390-PS-0039
June 2016
The WindObserver base has three
M5 tapped holes, 8mm deep.
Pipe Mounting (use with Pipe Mount)
The Pipe Mount base for the WindObserver 65 has the following dimensions.
Included in the supplied mounting kit is an O Ring Seal which must be fitted inside
of the Pipe Mount Base.
The mounting pole dimension should be 50mm (1.97”) diameter.
Three M5 x 12 hex screws are provided to secure the Pipe Mount to the WindObserver
base.
Three M5 x 12 hex screws to secure the Pipe Mount to the pipe through M5 tapped holes
in the Pipe Mount.
If a screw threaded pole is used it should be a 1.5 inch National Pipe Thread (NPT) type.
It is recommended that the WindObserver mounting pole be manufactured from Stainless
Steel 316, to prevent possible galvanic corrosion.
Custom Mount (Use with WindObserver No Mount Option)
Although it is recommended that customers select a base mount option from Gill
Instruments, should a customer wish to design their own mount then the WindObserver
base dimension details for this are as follows:-
North Alignment Dot
OD
56.60mm
4.50mm
