Gilera Stalker 50, Service Manual

Page: 25 / 164

Maintenance chart
MAINTENANCE TABLE
I: CHECK AND CLEAN, ADJUST, LUBRICATE OR REPLACE, IF NECESSARY
C. CLEAN, R:REPLACE, A:ADJUST, L:LUBRICATE
Clean the SAS air filter every 2 years
** Replace every 2 years
km x 1,000 1 5 10 15 20 25 30 35 40 45 50
SAS filter I I I I I
Steering A A A A A A
Odometer gear L L
Idle speed A A A A A A
Vehicle road test I I I I I I I I I I I
Sliding blocks / variable speed rollers I I I R I I I R I I
Tyre pressure and wear I I I I I I I I I I I
Brake Pads/Shoes I I I I I I I I I I I
Headlight aiming adjustment A A A A A
Hub oil R I I I R I I I R I I
Brake fluid ** I I I I I I I I I I I
Brake control levers L L L L L L
Electrical system and battery I I I I I I I I I I I
Air filter C C C C C C C C C C
Throttle control - mixer A A A A A A
Driving belt I R I R I R I R I R
Spark plug I R I R I R I R I R
Safety locks I I I I I I
Driven pulley roller casing L L L L L
Suspensions I I I I I
Transmissions L L L L L
Checking the spark advance
-Check to be made at over 4000 rpm with strobo-
scopic gun. The advanced ignition measured must
be 17° before the TDC.
- This value is correct when the reference mark on
the flywheel hood is aligned with the reference
mark on the cooling fan and the phase shifter on
the stroboscopic gun is set on 17°.
N.B.
IN CASE OF MALFUNCTION, CARRY OUT THE CHECKS
PROVIDED FOR IN THE ELECTRICAL SYSTEM CHAPTER.
CAUTION
BEFORE CARRYING OUT THE ABOVE CHECKS, CHECK
THE CORRECT KEYING OF THE FLYWHEEL ON THE
CRANKSHAFT.
Specific tooling
020330Y Stroboscopic light to check timing
Stalker 50
Maintenance
MAIN - 25