Gilera Stalker 50, Service Manual

Page: 51 / 164

or the wiring, otherwise carry on with
tests.
•
With the engine off, remove the regu-
lator connector, and insert the ends of
the tester between contact 5 and the
ground.
•
Move the key controlled switch to ON
and check there is battery voltage. If no
voltage is detected, check the wiring
and the contacts on the key switch and
on the battery.
•
Repeat the same procedure with the
ends of the tester inserted between
contact 5 (+) and 6 (-) and check the
presence of the battery voltage with the
key switch at on. If this does not hap-
pen, check the regulator's ground ca-
ble harness.
•
If these last two tests have a positive result replace the regulator because it is certainly not
functioning properly.
Specific tooling
020331Y Digital multimeter
Fuses
The electrical system is protected by a fuse con-
nected on the left-hand side of the helmet com-
partment next to the battery. For access it is
necessary to remove the battery cover and the
transparent protection over the fuse block. The ig-
nition system, headlight and the rear tail light are
not fuse-protected.
CAUTION
BEFORE REPLACING THE BLOWN FUSE,
SEARCH AND ELIMINATE THE BREAKDOWN
THAT HAS LED TO THE BLOW OUT.
NEVER TRY TO REPLACE A FUSE USING DIF-
FERENT MATERIAL (FOR EXAMPLE A PIECE
Stalker 50
Electrical system
ELE SYS - 51