Gilera Stalker 50, Service Manual

Page: 50 / 164

FAULT 4
Put the vehicle in gear and check when the tester
for the detection of alternate voltages put between
the blue cable connection and the yellow cable
connection on the stator, the voltage distributed by
the generator is within the values indicated. In the
case of malfunction, check the continuity of the
stator or continue with the tests.
Insert an ammeter between the stator (blue cable)
and the battery and check, with the tester, that the
current is properly distributed at 3000 rpm and the
battery is kept between 12 and 13V as indicated.
If the values detected are lower than those speci-
fied, replace the regulator; otherwise replace the
battery.
N.B.
BEFORE CARRYING OUT THE CHECKS ON THE REGU-
LATOR AND RELATIVE SYSTEM, IT IS ALWAYS GOOD
PRACTICE TO CHECK THAT THERE IS CONTINUITY BE-
TWEEN THE BLACK CABLE AND THE GROUND.
N.B.
TO KEEP THE BATTERY BETWEEN 12 AND 13V, CAUSING
CURRENT ABSORPTION BY THE SYSTEM, A 12V - 35W
BULB CONNECTED BETWEEN THE + BATTERY AND
GROUND CAN BE USED.
Specific tooling
020331Y Digital multimeter
Characteristic
Distributed current
1.5 to 2A
Voltage distributed at 3000 rpms
25 to 30V
FAULT 5
If the turn indicators do not work, do the following:
•
Without removing the connector from
the voltage regulator, move the key-
controlled switch to ON and verify the
presence of intermittent voltage be-
tween contact 7 and the ground. If
there is voltage, the failure must be at-
tributed to the flashing indicator switch
Electrical system
Stalker 50
ELE SYS - 50