Introduction
Page 2
MDE-3801 TRIND™ Multi 1 Transmitter/Receiver in Dispenser Retrofit Kit • 10/99
Required Tools
The following equipment is needed to install all TRIND™ Multi 1 kits
• Allen wrench set, American standard
• clean cloth or rag
• chip extraction tool, e.g., IC extraction, Digikey Part No. K158-ND or equivalent
• isopropyl alcohol (part# END-1082)
• needle nose pliers
• nut driver, 1/4'', 3/8''
• pocket knife
• Q12534 CRIND diagnostic card
• ratchet set, standard
• screwdrivers, flat and Phillips head
• static guard wrist strap
The following additional tools are required if kit is to be installed on wide frame
units with call or stop button on existing right options door.
• center punch
• deburring tool or round file
• hand drill, battery electric or pneumatic
• light hammer
• pilot drill bit (between 3/32” and 1/4”) and 7/8” drill bit
• standard tape measure or rule
