Omnia PCB
Omnia Tools
Page 5-50
MDE-5369E FlexPay™ IV (with Omnia) Programming and Service Manual · April 2020
Audio Video Test
If required, Omnia audio/video can be tested as follows:
1
Select
A/V Test side A/B
.
2
Set the Test Audio Volume.
3
Set the Test Duration.
4
Click
Start
.
Note: Some issues may be experienced if the test is run while Idle/Busy loops videos are
playing. It is advisable to disable the Applause Media System before starting the A/V
test and re-enable it again after the test is over. For more information, refer to
“Media Configuration for Applause Media System”
Figure 5-73: Starting Audio Video Test
5
Check if the test is running in the Results sections and the sample audio/video is playing.
6
The test can eventually be stopped by clicking
Stop
in Results section.
Figure 5-74: Audio Video Test Running
