Configuring FlexPay IV
Configuring CRINDBIOS for Software Version 42.11.XX or Later
Page 4-6
MDE-5369E FlexPay™ IV (with Omnia) Programming and Service Manual · April 2020
Configuring CRINDBIOS for Software Version 42.11.XX or
Later
To configure CRINDBIOS settings, proceed as follows:
Description
Screen
1 In the System Menu, press
<3> App Configuration
.
2 For units with the 15.6-inch display option, optimize
settings for the large display.
a In the App Config menu, press
<2> Display Manager
,
and change the Display Template setting to None.
b Press
<3> Auto Shift Content
and ensure that it is
set to Enabled.
c Press
Cancel
to go back to the App Config menu.
3 In the App Config menu, press
<1> CRINDBIOS
.
4 In the CRINDBIOS menu, press
<1> CRIND
and check
or set each of the following settings:
• CRIND
• DISPLAY
• CUSTOMIZATION
• DIAGNOSTICS
• PUMP
• PRINTER
5 Press
<1>
and set to
Yes
.
6 Press
<2>
and set Generic or MOC based on the POS
type.
7 Press
<3>
and set the CRIND ID.
8 Press
<4>
and set Interface type: Serial_4800/9600/
19200 or IP (for EMV) or COIP.
Note: Must be set to 9600 Baud for Commander POS, if
the serial interface is used.
9 Press
<5>
and set TLS mode if the IP interface mode
type depends on the POS configuration.
10 Press
<6>
and set Display Security Check to Enable.
11 Press
Cancel
to save and go back to the previous menu.
