MDE-4017G Mat Reader Assembly Kit (C00016-XXX) Installation Manual · April 2017
Page 33
Installing Mat Reader Assembly
Mounting Mat Reader Interface Box
To mount the mat reader interface box, proceed as follows:
1
Determine the location for the installation of indoor equipment. The interface box may be
mounted under the countertop (upside down) or vertically on one of the supporting walls of
the countertop.
Note: For connecting the mat reader interface box to the mat reader, refer to MDE-3620 POS
Systems Site Preparation Manual. Also, refer to
on
.
2
Use a Zircon stud/bracket finder to ensure no electrical conduits or pipes are located inside the
wall where the mat reader interface box is to be mounted. Also, ensure the mat reader interface
box is to be located where studs or wall (concrete/brick/drywall) mollys can be used for
mounting.
3
Do not use the mat reader interface box as a drill guide. It may be used as a template to
mark the holes to be drilled.
CAUTION
Mark and drill the holes. Insert the wall mollys, if required.
4
Use the 8-32-inch thread-forming screws provided or other appropriate contractor-supplied
mounting hardware to secure the mat reader interface box to the wall or under the countertop.
Note: 3/8-inches deep pilot holes (approximately 1/8 inches in diameter) are required if the
screws provided are used.
Figure 32: Mat Reader Interface Box Mounting Holes
Mounting Holes
