GILBARCO VEEDER-ROOT C00016 Series, Installation Manual

Page: 24 / 34

Installing Mat Reader Assembly
Page 24 MDE-4017G Mat Reader Assembly Kit (C00016-XXX) Installation Manual · April 2017
PIN Pad Mat Reader - Without Pedestal and Hole in Countertop
To install the PIN pad mat reader without pedestal and hole in the countertop, proceed as
follows:
Note: The PIN pad cable (supplied with the PIN pad) and Mat Reader Drive Cable
(M01872A002) are routed between the mat reader and PIN pad. The four Rubber
Bumpers (Q12226-01) are attached to the back of the adapter plate to keep it off the
countertop.
1
Place the PIN pad adapter plate face down on a clean, shock absorbing material (such as
corrugated cardboard or thick shop rag); then firmly hammer the three Q10227-06 Self
Clinching Nuts into the three holes in the back side of the PIN pad adapter plate (see
Figure 21
on page 25 ).
2 Attach the four adhesive-backed rubber bumpers to the back side of the PIN pad adapter plate
in the four corners (see
Figure 21 on page 25 ).
3
Route the mat reader drive cable from the interface box down through the D-shaped hole in the
PIN Pad Mat Reader [M02001GXXX (see
Figure 22 on page 26 )].
4 Carefully connect the P1/P2 connector of the mat reader drive cable to the connector on the
back of the PIN pad mat reader (see
Figure 18 on page 21 ).
5
Route a cable-tie through the designated hole in the PIN pad mat reader (see Figure 22 on
page 26 and Figure 18 on page 21 ) and around the mat reader drive cable, and pull the

cable-tie end through its locking slot. The cable-tie provides strain relief for the cable.
6
Route the PIN pad cable from the Passport system directly out of the back of the PIN pad

(see Figure 22 on page 26 ).
7 Carefully connect the connector on the PIN pad cable to the connector on the back of the

PIN pad.
8
Place the three Q11270-21 Screws through the screw holes in the PIN pad mat reader into the
front of the PIN pad adapter plate; and screw into the clinch nuts in the PIN pad adapter plate
leaving the screw heads 0.160 inches (4 mm) above the top of the PIN pad mat reader.
9
Align the three mounting holes on the bottom of the PIN pad over the three screws on the PIN
pad adapter plate/PIN pad mat reader combination.
10 Place the PIN pad on the PIN pad adapter plate/PIN pad mat reader combination so that the
screws go into the PIN pad’s mounting holes.
11
Gently slide the PIN pad down the PIN pad adapter plate/PIN pad mat reader combination so
that the screws fit firmly into the slot holes to form the PIN pad adapter plate/PIN pad mat
reader/PIN pad unit (see
Figure 23 on page 27 ).
12
Use the remaining cable-ties to secure the mat reader and PIN pad cables together for neat
appearance on the countertop (see
Figure 23 on page 27 ).