GILBARCO VEEDER-ROOT C00016 Series, Installation Manual

Page: 19 / 34

MDE-4017G Mat Reader Assembly Kit (C00016-XXX) Installation Manual · April 2017 Page 19
Installing Mat Reader Assembly
PIN Pad Mat Reader - with Pedestal and Hole in Countertop
To install the PIN pad mat reader with pedestal and hole in countertop, proceed as follows:
Note: The pedestal serves as conduit for the PIN pad cable (supplied with PIN pad) and the
Mat Reader Drive Cable (M01872A002).
1 If not already installed, use four screws to mount the PIN pad pedestal over a hole in the
countertop through which the PIN pad and mat reader drive cables will be routed.
2
Route the mat reader drive cable from the interface box through the pedestal and through the
hole in the base plate as shown in
Figure 17 on page 20 .
3 Carefully connect the P1/P2 connector of the mat reader drive cable to the connector at the
back of the PIN pad mat reader (see
Figure 18 on page 21 ).
4
Route a cable-tie through the designated hole in the PIN pad mat reader (see Figure 17

on page 20 and Figure 18 on page 21 ) and around the mat reader drive cable, and pull the
cable-tie end through its locking slot. This provides strain relief for the cable.
5
Route the PIN pad cable from the Passport system through the pedestal, PIN pad mat reader,
and hole in the PIN pad adapter plate (see
Figure 17 on page 20 ).
6 Carefully connect the connector on the PIN pad cable to the connector at the back of the PIN
pad.
7
Insert the three M01677B010 Screws through the corresponding holes in the common adapter
plate, PIN pad mat reader, and screw into the corresponding holes in the base plate

(see Figure 19 on page 21 ).
8
Align the three mounting holes on the bottom of the PIN pad over the three studs on the PIN
pad adapter plate.
9 Place the PIN pad on the PIN pad adapter plate so that the studs go into the PIN pad’s
mounting holes.
10
Gently slide the PIN pad down the PIN pad adapter plate so that the studs fit firmly into the
slot holes.
11 Connect the loose end of the work area cable from the interface box to the P3 port on the USB
converter (refer to
MDE-4157 Passport Combined Cashier/Manager Workstation,

MDE-4158 Passport Cashier Workstation, and MDE-4159 Passport Standalone Manager
Workstation
).