Gigamon GigaVUE TA Series, Hardware Installation Manual

Page: 73 / 108

Basic Connections and Configuration 73
• Configure time and date options for the node.
Refer to
Configuring GigaVUE TA Series Node’s Time Options on
page 77 .
• Enable the Web server for Web-based GUI access.
Refer to
Enabling the Web Server on page 79 .
• Save your changes!
Refer to
Saving Changes on page 82 .
Enter the Configure Command-Line Mode
Keep in mind that the GigaVUE-OS have three different command modes for
the CLI –
Standard , Enable , and Configure . The commands described in
the sections below are all only available in Configure mode. Switch to
configure mode as follows:
SSH, Telnet, or Both?
Both Telnet and SSH2 are available for remote connections to the GigaVUE
Traffic Aggregator’s
Mgmt port. By default, SSH2 is enabled and Telnet is
disabled. Use the ssh and telnet-server commands in Configure mode to
enable or disable the corresponding connections. To disable the
Command Notes
> enable
You only need to supply enough of each command to
positively identify it among the other available commands.
So, in this example, you could just type
ena and press
Enter.
# configure terminal
Similarly, this command can be entered as con t .
(config) #
Notice how the system prompt changes with each
command mode. Command modes offer greater control
over the box as you ascend from
Standard to Enable to
Configure .